24
Gutter Components Specification Listing
To customise and complete the model specification please select the items as required from the
following components list
SUMPS: Factory fabricated and sealed and supplied as part of a section of Unifold gutter.
Install fully in accordance with manufacturers instructions.
SIDE BOXES: Factory fabricated and sealed and supplied as part of a section of Unifold gutter. Install
fully in accordance with manufacturers instructions.
SECTION CHANGE: factory fabricated and sealed to include a small section of each gutter. Install fully
in accordance with manufacturers instructions
EXPANSION / CONTRACTION JOINT: Manufactured as an integral part of a Unifold section to be
installed between two fixed points ie:- two outlets / one outlet and at the stop-end / corner or junction.
To be fitted fully in accordance with manufacturers instructions.
System drawing number 1024
SIPHONIC OUTLET SECTIONS: Manufactured as an integral part of a Unifold section. To be fitted fully
in accordance with manufacturers instructions.
System drawing number 1026
CORNERS: factory fabricated and sealed. To be fitted fully in accordance with manufacturers
instructions
System drawing number 1027
TEES: Factory fabricated and sealed. To be fitted fully in accordance with manufacturers instructions.
System drawing number 1028
PERMANENT TIE-OFF ASSEMBLY: Supplied in component kit form to permanently terminate Unifold
within the length of the gutter ie:- at the party line of two buildings sharing the same gutter. Install fully
in accordance with manufacturers instructions.
System drawing number 1017
PVCU OVERFLOW UNITS 50mm DIAMETER x 300mm LONG: Supplied as a factory fabricated unit.
Install fully in accordance with manufacturers instructions.
System Drawing number 1035
SNORKEL OVERFLOW UNITS (For flashing existing overflows): Supplied as a factory manufactured
unit. Install fully in accordance with manufacturers instructions.
System drawing number 1025
gutter lining system
™
SNORKEL OVERFLOW UNITS (For the insertion of new overflows): Supplied as factory fabricated
unit. Install fully in accordance with manufacturers instructions
System drawings may be obtained from Ampteam on request.
UNIFOLD Gutter Components Specification Listing
01384 252777 unifold@ampteam.co.uk www.gutterliners.com
The
™
UNIFOLD Solution Phone us Click on email Click on website
Page 1 Page 2 Page 3 Page 4 Page 5 Page 6 Page 7 Page 8 Page 9 Page 10 Page 11 Page 12 Page 13 Page 14 Page 15 Page 16 Page 17 Page 18 Page 19 Page 20 Page 21 Page 22 Page 23 Page 24 Page 25 Page 26 Page 27 Page 28