SUBMERSIBLE
RESIDUE DRAINAGE
The LSC1.4S succeeded the famous LSC4, which was the original “puddle sucker”.
It is able to pump water down to 1mm, which makes it suitable for pumping large or small
areas of nuisance water found on fl at surfaces. This new, updated, model incorporates
LSC 1.4S
a dual position 25mm(1”) outlet port, to enable the user to position the outlet hose
horizontally or vertically and avoid it kinking; 50mm(2”) is also available, as an optional
extra. For improved durability, during robust handling, it has a pressed steel outer casing
✔ Hire fl eets ■ 25mm (1”) –
and a cast aluminium pump stand to offer increased protection of the steel and rubber
✔ Utilities 50mm (2”) outlet
base plate. A combination of a rubber pump chamber and a urethane vortex impeller ✔ Basements ■ manual
enables the design to offer excellent wear resistance in site water applications that contain
✔ Roofs ■ automatic
sand and silt in suspension, thus maintaining performance and reliability. An additional
■ 110 volts
feature is an integral swing check valve to prevent back fl ow of water from the discharge
hose. Quality is further enhanced with a 403 stainless steel shaft that is fi tted with an ultra
■ 230 volts
hardwearing, silicon carbide, double mechanical seal (in an oil chamber), and an oil lifter
to maintain seal lubrication during operation in any position. This feature, combined with
the water and air cooling route to the top outlet, allows the pump to operate for extended
periods with little or no water. Used widely by hire outlets, utilities and fl ood control
companies. Supplied with 10 metres of heavy duty, H07RN-F rubber power cable.
For precise water level control we recommend the use of the SwitcH2O as an optional
extra (see page 47). 3 probes, in 304 stainless steel, are set in a epoxy-resin fi lled holder
and they represent on, off and common. The common must always be the lowest point
of the probes, while the on and off can be cut to any size from 5mm to 50mm, from the
base of the pump, but must have a minimum difference of between 3 and 5mm.
The SwitcH2O should be used in conjunction with a QA50B control panel (optional extra
see page 49). It is supplied with 10 metres of low voltage, PVC power cable.
SwitcH2O 50mm outlet
LSC1.4S
ACCESSORIES
Hoses page 91
Level control page 47
Hose clips page 104
model Manual outlet kW volt fl ow head free dia x h (mm) weight
or Auto (mm) (l/min) (mtrs) passage (kgs)
(mm)
LSC1.4S M 25 0.48 110 230 170 11 6 Ø196x316 12.0
LSC1.4S M 50 0.48 110 230 170 11 6 Ø196x316 12.0
Optional extra: SwitcH2O level control (see page 47)
CALL: FREEPHONE 0800 092 4423 11
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70 |
Page 71 |
Page 72 |
Page 73 |
Page 74 |
Page 75 |
Page 76 |
Page 77 |
Page 78 |
Page 79 |
Page 80 |
Page 81 |
Page 82 |
Page 83 |
Page 84 |
Page 85 |
Page 86 |
Page 87 |
Page 88 |
Page 89 |
Page 90 |
Page 91 |
Page 92 |
Page 93 |
Page 94 |
Page 95 |
Page 96 |
Page 97 |
Page 98 |
Page 99 |
Page 100 |
Page 101 |
Page 102 |
Page 103 |
Page 104 |
Page 105 |
Page 106 |
Page 107 |
Page 108 |
Page 109 |
Page 110 |
Page 111 |
Page 112 |
Page 113 |
Page 114 |
Page 115 |
Page 116