Hypoxic Death & the Exit Bag 69
Construction (See Fig 5.5)
1. Lay the bag out on a flat surface and folded back ~ 25mm
(1”) around the open end (A-B)
2. Make a 25mm cut in the folded polyester
3. Lay the elastic (C) inside the fold and had the two ends exit
through this cut
4. Tape completely along the folded edge of the plastic with
the sticky tape
5. Place a cut in a ~ 60mm piece of duct tape and folded this
over the exiting elastic to strengthen this part of the bag
6. Thread a small wire tie through two cuts in another piece
(~50mm) of duct tape and stuck this to the inside of the bag
~ 15cm up from the elastic (E). This can be used to secure
the plastic helium hose inside the bag.
7. The toggle was then threaded onto the two ends of the elastic
to complete the bag (D)
Fig 5.5: Exit Bag Manufacture
Fig 5.6: The completed Exit Bag
Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11